JTAG J2534 Power Box for KTM JTAG for Hitachi KTM FLASH Car ECU Programmer 3 mod

JTAG J2534 Power Box for KTM JTAG for Hitachi KTM FLASH Car ECU Programmer 3 modes

Description:
It is compatible in the automatic mode with the loading programs which use:
BOOT-OEM12, 12 pin OBD-II;
L-LINE, 15 pin OBD-II.

The Tool has built-in current limiting resistors on the following signal lines:
RESET — 510 Ω;
BOOT — 510 Ω;
CNF1 — 220 Ω.


In conclusion:
All programming tools above can be used for ECU read and write, but differs in ECU coverage and Read/Write method.
There is NO LIMITS of the car model and year when using KTM bench to read/write data.

But if you have chips and gearboxes to read and write, you should have a KTM flash. The bad is: disassembling is required. KTM bench doesn’t cover chips and gearboxes and KTM OBD cannot not work good for gerabox Read/Write.

So, you’d better check the ECU/gearbox/chip before your purchase.
Check each car list on corresponding product page.


The tool is fitted with multipurpose connectors which allow to establish the con